Improving Ink Adhesion; Additional Uv Lamp Illumination After Printing - Roland VersaUV LEF2-200 User Manual

Improving Ink Adhesion

Additional UV Lamp Illumination after Printing

When the ink is not completely cured after printing is complete, cure the ink by illuminating it once again with the
UV-LED lamp.
A characteristic of UV ink is that it cures quickly when exposed to light from the UV-LED lamp, but curing may be
difficult for materials that absorb ink like cloth. This function may alleviate this symptom.
Procedure
1.
Press [FUNCTION].
2.
Press [▼] several times to display the screen shown below.
FUNCTION
UV SCANNING
3.
Press [▼] several times to display the screen shown below.
4.
Press [ENTER].
The print heads move, and the print area is illuminated by the UV-LED lamp.
MEMO
• This function cannot be used if the setup of the object to be printed on has been canceled ([SETUP] is
off).
• The UV-LED lamp illuminates the print area configured in the setup of the object to be printed on.
• To change the range of emission, readjust the print area.
• The effect depends on the material of the object to be printed on.
• You can stop the operation by pressing [ENTER] while operation is in progress.
TO CANCEL
PRESS ENTER KEY
• With VersaWorks, you can configure the settings so that additional emission continues after printing
without using this function. For more information, refer to .
VersaWorks Help
2. Optimizing the Printing Quality
79