Step 2: Start Printing - Roland VersaUV LEF2-200 User Manual

Printing method

Step 2: Start Printing

1.
Attach the object to be printed on.
MEMO
This section assumes that you are printing for the first time or immediately after changing the object to be printed on. Therefore, "SET
AT SETUP" is set to "ENABLE." When repeatedly printing in the same position on objects to be printed on that have the same shape,
we recommend that you set "SET AT SETUP" to "DISABLE" (
Procedure
1.
Check that the following screen is displayed.
SETUP MEDIA
If this screen is not displayed, check that nothing has been placed on top of the flat table, and then hold
down [SETUP] for 1 second or more.
[SETUP] turns off, and the flat table comes forward.
The above screen appears, and the object to be printed on can be set up.
2.
Open the front cover.
IMPORTANT
Be sure to hold the handle of the front cover and open and close it gently.
3.
Secure the object to be printed on.
A jig might be required according to the shape of the object to be printed on.
The following figure shows an example of using jigs to fit the shape of the object to be printed on. The jigs
are secured by double-sided tape attached to the bottom side.
RELATED LINKS
・ P. 32 "Three Checks before Printing"
44
1. Printing Operations
Omitting the Setting of the Print Area(P. 85)
).