Determining The Maximum Value (Threshold) For Automatic Height Adjustment - Roland VersaUV LEF2-200 User Manual

Determining the Maximum Value (Threshold) for Automatic Height Adjustment

You can set the maximum value (the threshold) to use when automatically adjusting the height of the table during
printing.
This setting is only enabled when "CLEARANCE MODE" is set to "RE-ADJ."
Procedure
1.
Press [MENU].
2.
Press [▼] to display the screen shown below.
MENU
SUB MENU
3.
Press [▶].
4.
Press [▼] several times to display the screen shown below.
SUB MENU
CLEARANCE MODE
5.
Press [▶], then [▼] to display the screen shown below.
CLEARANCE MODE
THRESHOLD
6.
Press [▶].
7.
Press [MENU], then [◀] to go back to the original screen.
MEMO
The greater the distance between the print surface and the print head, the greater the trend for the printing image quality to
drop. Therefore, it is beneficial to minimize the adjustment width. Keep the following points in mind when determining the
setting value.
• Consider the effect on the printing image quality in order to obtain satisfactory image quality.
• The variation in height across the entire print surface (not the print target area but including parts that will not be printed)
Adjusting the Height
1. Optimizing the Setup Method
63