Roland VersaUV LEF2-200 User Manual page 127

Maintenance That Must Be Performed Daily
3.
Attach the object to be printed on for the printing test.
Attach the object to be printed on for the printing test. Use paper for testing (width 90 mm (3.54 in.) × length 70
mm (2.76 in.) or more), not the object that will actually be printed on.
Procedure
1.
Check that the following screen is displayed.
SETUP MEDIA
If this screen is not displayed, check that nothing has been placed on top of the flat table, and then hold
down [SETUP] for 1 second or more.
The flat table will come forward into a position in which the object to be printed on can be set up.
2.
Open the front cover.
IMPORTANT
Be sure to hold the handle of the front cover and open and close it gently.
3.
Secure the paper for the printing test.
Printing tests are used to check that no dot drop-out occurs. Use paper for testing (width 90 mm (3.54 in.) ×
length 70 mm (2.76 in.) or more), not the object that will actually be printed on.
MEMO
There are two types of printing tests. Select the paper to be used based on the features of the given type.
Type
CLEANING
TEST PRINT
CLEANING
TEST PRINT2
MEMO
Affixing the media with tape
Secure the media in place using a substance such as commercially available tape affixed directly to the flat table. This method
can be used for thin paper and other such media that can be secured with tape only. It can be set anywhere as long as it does
not protrude from the top of the flat table. Be aware that folds or kinks in the paper might hit the interior of the printer and
cause damage.
4.
Close the front cover.
126
2. Regular Maintenance
Features
It is difficult to check the white ink if the paper for use in the printing test is white. We
recommend printing on transparent paper.
Because white ink is printed on a black undercoat, white ink can be easily checked even
when printed on white paper. However, printing takes longer than "TEST PRINT."