Roland VersaUV LEF2-200 User Manual page 136

13.
Press [ENTER].
SET HEAD
REFRESHER
14.
When the following screen is displayed, apply head refreshing cleaning liquid to the head cleaning sheet.
Point
• As a guideline, apply 2 drops of cleaning liquid to a single cleaning pad. Apply 1 drop of cleaning liquid in each location,
using the holes in the sheet retaining cover (8 holes in the front and 8 holes in the back for a total of 16 holes) as guidelines
for the positions where to apply the liquid.
• Soak the cleaning liquid into the entirety of the head cleaning sheet covering the wiping part. Rubbing the print heads with a
dry sheet may lead to malfunctions.
IMPORTANT
Do not leave the bottle of cleaning liquid for head refreshing on the flat table.
Leaving the cleaning liquid bottle on the flat table and proceeding to the next operation will lead to an error caused by the
bottle hitting the head gap sensor.
15.
Close the front cover.
16.
Press [ENTER].
APPLY CL-LIQUID
START REFRESH
The screen shown below appears, and the head refresh starts. The (approximate) remaining time for the
procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45
seconds")
CLEANING...
>>
MEMO
If the possibility of the print heads hitting the head refresher (or some other obstacle) is detected, head refreshing is canceled
and the following message is displayed.
CHECK HEIGHT OF
HEAD REFRESHER
Press [ENTER] to clear the message.
If the jig is in the way or has not been attached correctly, the head refresher position may be too high. Correctly reattach the
head refresher by removing the jig or reviewing how the jig is attached. Then, perform head refreshing again.
17.
When the following screen is displayed, open the front cover.
REMOVE HEAD
REFRESHER
01:45
Maintenance That Must Be Performed Daily
2. Regular Maintenance
135