Roland VersaUV LEF2-200 User Manual page 165

Handling Severe Dot Drop-out
5.
Close the front cover when it is open.
6.
Press [ENTER].
The print area is specified. Print heads return to the standby position.
7.
Make sure the "W" (width), "L" (length), and "H" (height) values on the menu screen are as intended.
W: 90mm L: 70mm
H:100.0mm
MEMO
• If you want to use the print area specified here for the next printing operation, switch "SET AT SETUP" (
the Print Area(P. 85)
and base position.
• Automatic return is not possible for a set base printing position (home position). In other words, the setting must be config-
ured again if the base printing position (home position) differs, such as when selecting a new object to be printed on.
164
3. Advanced Maintenance
) to "DISABLE." With this setting, you can set up the object to be printed on without setting the print area
Omitting the Setting of