Attaching And Removing The Power Supply Unit (Accessory); Attaching And Removing The Power Supply Unit To The Support; Attaching And Removing The Power Supply Unit With Support To The Universal Bracket - Atmos C 051 Thorax Operating Instructions Manual

7.5

Attaching and removing the power supply unit (accessory)

1
2
7.5.1

Attaching and removing the power supply unit to the support

7.5.2 Attaching and removing the power supply unit with support to the universal
bracket
Assembly recesses
1
Recess for storage of power supply unit and power
2
supply cable
1. Place the support on the power supply unit by placing
the mounting recesses of the support over the power
supply unit mounting recesses.
2. Tighten the support with the provided screws and the
recommended screwdriver (TORX - screwdriver - T10).
3. Remove the support with the provided screws and the
recommended screwdriver (TORX - screwdriver - T10).
 Firmly hold the power supply unit which is attached to
the support during the entire process.
1. Attach the universal bracket (Chapter „7.1 Attaching
the universal bracket (Accessories)" on page 35).
2. Place the support with power supply unit to the
universal bracket by positioning the thread on the
bottom of the support with power supply unit over the
fixing screw of the universal bracket.
3. Turn the fixing screw on the universal bracket in a
clockwise direction in order to mount the power
supply unit support to it.
 The support with the device must always be affixed in
a horizontal position.
4. To remove the support with power supply unit loosen
the fixing screw on the universal bracket by turning it
counter-clockwise.
39