Attaching The Carrying Handle; Removing The Carrying Handle; Attaching The Disposable Strap - Atmos C 051 Thorax Operating Instructions Manual

7.8.2

Attaching the carrying handle

To attach the carrying handle, the strap holder clips and screws are required. These are
provided on the device.
Correct Incorrect
7.8.3

Removing the carrying handle

To remove the carrying handle from the device, loosen the screws by 3 turns with the
recommended screwdriver (TORX - screwdriver - T10) out of the strap clips on the back of the
device.
7.8.4

Attaching the disposable strap

1
Strap carabiner for attaching to carrying handle or strap holders.
+
7.8.4.1 Attach the disposable strap to the carrying handle
To attach the disposable strap to the carrying handle, the device with the mounted carrying
handle is required (Chapter „7.8.2 Attaching the carrying handle" on page 41).
1. Loosen the screws on the back of the device by 3
turns with the recommended screwdriver (TORX -
screwdriver - T10).
2. If necessary remove the strap holders.
The curve of the carrying handle must point towards the
front of the device.
3. Insert the recesses of the carrying handle in the
provided strap holder clips and press the carrying
handle inwards, until it clicks into place.
 Pay attention to a maximum tightening torque of 0,7
Nm.
4. Tighten the carrying handle with the provided screws
and the recommended screwdriver (TORX - screwdriver
- T10).
2
41