Handling Connectors - Kubota D1803-CR-E4 Workshop Manual

GENERAL WORKING PRECAUTIONS

10. Handling connectors

(1) Fuse
(2) Fusible link
10. Handling connectors
• When disconnecting the locking connectors, be
sure to disengage the lock before disconnecting.
There are two kinds of locks: one requires pressing
and the other requires pulling.
(A) Press
• Pull the connector
disconnecting the connectors.
• Do not pull the wire harness to separate.
(B) Correct
• Make sure the terminal condition of the connectors
is not bent, rusty, and so on.
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
(3) Slow blow fuse
body securely when
(C) Incorrect
• If the terminal is rusted, remove rust with
sandpaper.
(1) Missing terminal
(2) Bent terminal
(3) Sandpaper
• Cover the female bullet terminals and male bullet
terminals securely with the waterproof plastic
covers.
• Make sure that the bullet terminals are secure and
connected securely to the tip.
(B) Correct
• Cover the female connectors and male connectors
securely with the waterproof plastic covers.
(5) Cover
(B) Correct
2. GENERAL
(4) Rust
(C) Incorrect
(C) Incorrect
2-5
KiSC issued 12, 2018 A