Installing Cylinder Head Cover; Installing Sensors - Kubota D1803-CR-E4 Workshop Manual

SERVICING
6. Assembling
2. Install the glow lead (3).
Tightening tor- Glow lead mount-
que ing nut
(1) Glow plug

6.32 Installing cylinder head cover

NOTE
• Replace the gasket with a new one.
1. Install the cylinder head cover (1) and tighten to the
specified torque.
Tightening tor- Cylinder head cov-
que er screw
(1) Cylinder head cover

6.33 Installing sensors

IMPORTANT
• If you drop the sensor, do not reuse it.
NOTE
• Replace the gasket with a new one.
• Replace the O-ring with a new one.
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
0.980 to 1.77 N⋅m
0.100 to 0.180 kgf⋅m
0.723 to 1.30 lbf⋅ft
(3) Glow lead
6.86 to 11.3 N⋅m
0.700 to 1.15 kgf⋅m
5.06 to 8.33 lbf⋅ft
1. Install the coolant temperature sensor (1) and
tighten to the specified torque.
Tightening tor- Coolant tempera-
que ture sensor (1)
(1) Coolant temperature sensor
2. Install the camshaft position sensor (2).
3. Tighten the camshaft position sensor mounting
screw (3) to the specified torque.
NOTE
• If replace the camshaft position sensor,
measure the air gap between camshaft
position sensor and pulsar gear.
Service specifi-
Air gap
cation
Camshaft position
Tightening tor-
sensor mounting
que
screw (3)
(2) Camshaft position sensor
4. Install the crankshaft position sensor (4).
4. ENGINE
15.7 to 19.6 N⋅m
1.60 to 1.99 kgf⋅m
11.6 to 14.4 lbf⋅ft
0.20 to 1.3 mm
0.0079 to 0.051 in.
9.81 to 11.3 N⋅m
1.00 to 1.15 kgf⋅m
7.24 to 8.33 lbf⋅ft
(3) Camshaft position sensor
mounting screw
4-153
KiSC issued 12, 2018 A