Installing Glow Plug - Kubota D1803-CR-E4 Workshop Manual

4. ENGINE
• Store the injectors so they do not get any dust
in them.
• If replace the injectors, it is necessary to
perform injector correction (writing the injector
ID codes (1) to the engine ECU).
(1) Injector ID code
1. Install the injector (2) and its gasket (4).
NOTE
• Replace the injectors' gaskets (4) with new
ones.
2. Install the injector clamp (3) and tighten to the
specified torque.
NOTE
• When installing injector clamps (3), correctly
set them as shown in the drawing.
Tightening tor- Injector clamp
que screw (5)
4-152
23.5 to 27.5 N⋅m
2.40 to 2.80 kgf⋅m
17.4 to 20.2 lbf⋅ft
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
(2) Injector
(3) Injector clamp
(4) Gasket
RELATED PAGE
7.56 Replacing injector on page 4-191

6.31 Installing glow plug

1. Install the glow plugs (1).
NOTE
• Adjust the direction of the ditch to the
terminal side when the seal (2) is installed in
the glow plug (1).
• After installing the glow plug (1), make sure
that the seal (2) was set to the specified
position.
Tightening tor-
Glow plug
que
(1) Glow plug
(2) Seal
(A) Good
SERVICING
6. Assembling
(5) Injector clamp screw
14.7 to 19.6 N⋅m
1.50 to 1.99 kgf⋅m
10.9 to 14.4 lbf⋅ft
(B) Bad
KiSC issued 12, 2018 A