Installing Crank Gear; Installing Oil Pump; Installing Camshaft With Cam Gear - Kubota D1803-CR-E4 Workshop Manual

4. ENGINE
3. Install the oil pan (3).
NOTE
• Mount parts with a liquid gasket within 10
minutes of application.
• Tighten the mounting screws of the oil pan
(3) in diagonal sequence from the center to
tighten equally.
• Install the oil pan (3) with its central drain
plug facing toward the air suction side.
(3) Oil pan

6.13 Installing crank gear

1. Install the crank gear (1).
(1) Crank gear
2. Install the idle gear shaft.

6.14 Installing oil pump

1. Install the oil pump (1).
4-144
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
(1) Oil pump
2. Install the oil pump drive gear 1 (2).
NOTE
• After oil pump drive gear 1 (2) installed,
loosely tighten the oil pump drive gear 1
mounting nut (3).
Tighten the oil pump drive gear 1 mounting
nut (3) completely to the specified torque
after installing oil pump drive gear 2.
Oil pump drive
Tightening tor-
gear 1 mounting
que
nut (3)
(2) Oil pump drive gear 1
6.15 Installing camshaft with cam
gear
1. Install the camshaft (1) with cam gear (2).
SERVICING
6. Assembling
78.5 to 88.3 N⋅m
8.01 to 9.00 kgf⋅m
57.9 to 65.1 lbf⋅ft
(3) Oil pump drive gear 1
mounting nut
KiSC issued 12, 2018 A