Installing Fuel Camshaft With Supply Pump Gear; Installing Idle Gear - Kubota D1803-CR-E4 Workshop Manual

Hide thumbs Also See for D1803-CR-E4:
Table of Contents

Advertisement

SERVICING
6. Assembling
2. Tighten the camshaft set screw to the specified
torque.
Tightening tor-
Camshaft set
que
screw
(1) Camshaft
6.16 Installing fuel camshaft with
supply pump gear
1. Install the fuel camshaft with supply pump gear (2).
2. Install the fuel camshaft stopper (1).
NOTE
• After installing the fuel camshaft, store oil in
the pump room as shown in drawing
Recommended oil amount: More than 50 ml
(cc)
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
23.5 to 27.5 N⋅m
2.40 to 2.80 kgf⋅m
17.4 to 20.2 lbf⋅ft
(2) Cam gear
(1) Fuel camshaft stopper
(2) Fuel camshaft with supply
pump gear

6.17 Installing idle gear

1. Install the idle gear (2) and idle gear collar.
IMPORTANT
• Apply the engine oil inside of idle gear (2).
• When mounting idle gear (2), bring the
piston of cylinder 1 to T.D.C. and mount the
gears with their marks aligned to the
respective gears.
a. Idle gear (2) and cam gear (3)
b. Idle gear (2) and crank gear (4)
c. Idle gear (2) and supply pump gear (1)
(1) Supply pump gear
(2) Idle gear
(3) Cam gear
2. Tighten the idle gear mounting screw to the
specified torque.
Tightening tor-
Idle gear mounting
que
screw
4. ENGINE
(3) Oil
(4) Crank gear
(5) Oil pump drive gear 1
23.5 to 27.5 N⋅m
2.40 to 2.80 kgf⋅m
17.4 to 20.2 lbf⋅ft
4-145
KiSC issued 12, 2018 A

Advertisement

Table of Contents
loading

Table of Contents