Handling Fuses; Handling Connectors - Kubota WSM 05-E4B Series Workshop Manual

GENERAL WORKING PRECAUTIONS
9. Handling fuses
(2) Wire harness
• Do not pinch the wire harness when installing parts.
(4) Wire harness

9. Handling fuses

• Always use fuses of the specified capacity.
• Do not use steel or copper wiring instead of fuse.
• Do not install work light or radio without auxiliary
power line.
• Do not install auxiliaries to the fuses. The fuses
may blow.
(1) Fuse
(2) Fusible link
05-E4B SERIES,05-E4BG SERIES
(3) Clamp
(L) Bad
(3) Slow blow fuse

10. Handling connectors

• When disconnecting the locking connectors, be
sure to disengage the lock before disconnecting.
There are two kinds of locks: one requires pressing
and the other requires pulling.
(A) Press
• Hold on tightly to
disconnecting them.
• Do not pull wire harness itself.
(B) Correct method
• Make sure the terminal condition of the connectors
is not bent, rusty, and so on.
• If the terminal is rusted, remove rust with
sandpaper.
However, do not polish the terminal of the
waterproof connector or the plated terminal.
2. GENERAL
the connectors when
(C) Incorrect method
2-5
KiSC issued 03, 2023 A