Installing Crs Intermediate Harness - Kubota D1803-CR-E4 Workshop Manual

SERVICING
6. Assembling

6.41 Installing CRS intermediate harness

1. Connect the engine intermediate harness (engine side).
(1) Camshaft position (G) sensor
connector (3P)
(2) Crankshaft position (NE) sen-
sor connector (3P)
(3) Oil pressure switch connector
(1P)
(4) Name plate
(5) Coolant temperature sensor
connector (2P)
2. Connect the injector intermediate harness (engine side).
(4) Name plate
(22) Injector connector (10P)
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
(6) Intake throttle valve connector
(6P)
(7) Rail pressure sensor connec-
tor (3P)
(8) Fuel temperature sensor con-
nector (2P)
(9) Suction control valve (SCV)
connector (2P)
(23) Injector intermediate connec-
tor (12P)
(10) Boost pressure sensor con-
nector (3P)
(11) Intake air temperature sensor
connector (2P)
(12) Resistor 120 Ω (2P)
(13) Resistor 1.1 kΩ (2P)
(14) EGR valve connector (3P)
(15) CAN connector (4P)
(16) CAN connector (4P)
(k) Clamp
4. ENGINE
(17) Engine intermediate connector
(18) Engine joint connector 4 (8P)
(19) Engine joint connector 3 (8P)
(20) Engine joint connector 2 (10P)
(21) Engine joint connector 1 (6P)
(a) Clamp
to (j)
4-159
KiSC issued 12, 2018 A