Installing Common Rail - Kubota D1803-CR-E4 Workshop Manual

4. ENGINE
5. Tighten the crankshaft position sensor mounting
screw (5) to the specified torque.
NOTE
• If replace the crankshaft position sensor,
measure the air gap between crankshaft
position sensor and flywheel.
Service specifi-
Air gap
cation
Crankshaft posi-
Tightening tor-
tion sensor mount-
que
ing screw (5)
(4) Crankshaft position sensor
6. Install the boost pressure sensor (6).
7. Tighten the boost pressure sensor mounting screw
(7) to the specified torque.
Boost pressure
Tightening tor-
sensor mounting
que
screw (7)
(6) Boost pressure sensor
RELATED PAGE
4.31 Adjusting air gap between crankshaft position
sensor and flywheel on page 4-114
4-154
0.30 to 1.5 mm
0.012 to 0.059 in.
9.81 to 11.3 N⋅m
1.00 to 1.15 kgf⋅m
7.24 to 8.33 lbf⋅ft
(5) Crankshaft position sensor
mounting screw
9.81 to 11.3 N⋅m
1.00 to 1.15 kgf⋅m
7.24 to 8.33 lbf⋅ft
(7) Boost pressure sensor
mounting screw
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
4.32 Adjusting air gap between camshaft position
sensor and pulsar gear on page 4-115

6.34 Installing common rail

IMPORTANT
• Replace the rail assembly, if the exchange of
the pressure limiter (1) or the rail pressure
sensor (3) is necessary.
NOTE
• Do not remove the pressure limiter (1) and rail
pressure sensor (3) from the common rail (2).
• When installing the common rail (2), do not hold
it by the pressure limiter (1) and rail pressure
sensor (3).
1. Install the common rail (1).
(1) Pressure limiter
(2) Common rail
2. Connect the overflow pipe and hose (4).
3. Tighten the overflow pipe joint screw to the
specified torque.
4. Install the injection pipes (5).
SERVICING
6. Assembling
(3) Rail pressure sensor
KiSC issued 12, 2018 A