Afe Application Monitoring Values - Vacon NX ACTIVE FRONT END II Applications Manual

Arfiff05 Standard AFE-II
5.

AFE APPLICATION MONITORING VALUES

On the next pages you will find the lists of parameters within the respective parameter groups.
Column explanations:
Code = Location indication on the keypad; Shows the operator the present parameter
number
Parameter = Name of parameter
Min = Minimum value of parameter
Max = Maximum value of parameter
Unit = Unit of parameter value; Given if available
Default = Value preset by factory
Cust =
ID = ID number of the parameter
_____ = On parameter code: Parameter value can only be changed after the Drive has been
stopped.
_____ = Monitoring value is possible to control from fieldbus by ID number
The manual presents signals that are not normally visible for monitoring. i.e. is not a parameter or
standard monitoring signal. These signals are presented with [Letter]. e.g.
[FW]MotorRegulatorStatus
[V] Normal monitoring signal
[P] Normal parameter in application.
[FW] Firmware signal, Can be monitored with NCDrive when signal type is selected Firmware
[A] Application signal, can be monitored with NCDrive when signal type is selected Application.
[R] Reference type parameter on keypad.
[F] Function. Signal is received as a output of function.
[DI] Digital input signal.
CB Circuit Breaker
MCB Main Circuit Breaker = AFE controller Circuit Breaker
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
vacon • 17