Installing the Light-Lock Gasket
This installation procedure assumes that a hole has already been made in the wall for the
PROCESSOR and the PLYWOOD mounted to the wall around the hole. Recommended
minimum size of the hole is 87 cm x 76 cm (34 x 30 in.) at the correct height from the floor. See
Figure 6 and the Site Specifications, Publication Part No. 2B6842.
[1]
Install the LIGHT-LOCK GASKET to the MOLDING. See Figure 7 on page 10.
2B6843
NOTE
.
.
Figure 6 Installing the Light-Lock Gasket
PLYWOOD
MOLDING
LOCK-LIGHT
GASKET
PROCESSOR
Top View
wall
SCREW (2)
.
H104_0082DCA
9