B Roller; Removing And Installing The B Roller; Checking The Guide Shoes - Kodak X-Omat 480 RA Service Manual

B Roller

Removing and Installing the B Roller

[1] Remove the ROLLER from the SHAFT. Pull
the BEARING with the SHAFT.
[2] Install the ROLLER onto the SHAFT.
[3] Check that the CHAIN has the correct tension.
See figure 2-10.

Checking the Guide Shoes

[1] Check that the LONG TIPS are in the
direction of film travel. See figure 2-2.
LONG
TIP
Figure 2-9 Checking the Guide Shoes
246616
GUIDE SHOE
SHORT
TIP
H048_0155CCA
H048_0155CA
CROSSBAR
Direction of Travel
Figure 2-10 Checking the Tension of the Chain
DRIVE
GEAR
4 ADJUSTING
SCREWS
HOLDING
SCREW
TURNAROUND
ASSEMBLY
LINK
H048_0125CCA
H048_0125CA
2-11