Table of Contents
Advertisement
R
O
E C O R D
P T I O N S
There are four buttons in this group, many of which can be found in other pop-up windows, but
here they are collected in one place.
Merge
Replace
Insert Before
Insert After
Remove
R
ECORD
The Record Remove function is similar to a clear function except that where the Clear function
will remove an attribute from the programer, the Record Remove function will remove the
attribute from a cue. To use Record Remove, follow these steps:
1 Using the Mac 2k's from the Maxxyz Demo.scn file, record a cue 1 using intensity, pan, tilt, and
gobo.
2 Clear the programmer and playback the cue.
3 Select the odd numbered Mac 2k's by pressing the "2k Profile-2" group.
4 Place a value in the programmer for the "Gobo 1" wheel. It can be any non-null value. (This will
work on any attribute as well).
C
A T E G O R Y
When selected, the merge command will add all selected attributes to the
specified cue, group or preset. Attributes that were previously in the cue,
group or preset will not be affected unless they are carried in the
information to be added.
Where Merge adds information, the Replace function will overwrite all
existing attributes. Any previously existing attribute values will be erased
and the specified contents of the programmer will be put in their place. This
can be used with cues, groups and presets.
Used exclusively with cues, this command will insert the specified
programmer data as a "point cue" immediately before the specified cue.
Same as "Insert Before" except information is added after the specified
cue.
This function is similar to the Clear functions listed earlier and require
additional discussion. Please see below.
R
EMOVE
Recording Cues
87
Advertisement
Table of Contents
