Delay Fanning From Multiple Points - Martin Professional Maxxyz User Manual

4 Using the trackbelt below the "Tilt" legend in the programmer touch screen, focus the MAC 2k's
downstage.
5 Press the Delay LCD key in the Playback Command.
6 Press the Pan/Tilt LCD key in the programmer controls.
7 On the main keypad, press 0 Thru 10.
At this point if you look at the command line, you'll see the following:
8 Press Enter.
By looking at the programmer, you can see that the delay time of zero to 10 seconds has been
evenly distributed across the 12 fixtures.
To complete this operation,
9 Press Record and the Playback LCD used to create cue 1
10 Press Clear to clear the programmer.
D F
ELAY ANNING FROM
In much the same way that a standard fan is created, you can use change the delay time so that
the fade will begin at multiple points throughout the selected fixtures. For example:
1 Press Edit Cue 2 Enter
2 Press the Delay LCD key in the Playback Command.
3 Press the Pan/Tilt LCD key in the programmer controls.
4 On the main keypad, press 0 Thru 5 Thru 0 Enter.
5 Press Update Enter.
Now, when cue 2 is executed, you will see that the fan begins from the beginning and end of the
selected fixtures and works its way towards the middle. Conversely, had we wished to start in the
middle and work out, we would set the delay time to 10 Thru 0 Thru 10. It is possible to use
multiple "Thru" commands to construct your fan effect.
106
M P
ULTIPLE OINTS
Maxxyz