Assembly - Shake - H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List

ELECTRO FREEZE Soft Serve Model GEN-2080
11 Assembly
Figure 11-1 Shaft Seal Assembly
Figure 11-2 Beater Shaft Assembly
185240
— Shake
SEAL-ASSY. SHAFT
CUP SEAL
WASHER
O-RING
BEATER-ASSY. SHAKE LONG
BLADE-SCRAPER
Correct assembly of the
freezer is essential to prevent
leakage of the product and damage to
the freezer. To assemble the freezer you
will need an approved lubricant (such
as Petrol-Gel). Make sure all parts of
the assemblies have been washed and
sanitized before assembling.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are
in the "OFF" position and
that the main power supply
is disconnected. Some
freezers have more than
one disconnect switch.
1. Persons assembling the freezer
must first wash and sanitize their hands
and forearms with an approved sanitizer.
2. See figure 11-1. To assemble
the shaft seal, install the cup seal and
O-ring on the bushing. Apply a moderate
amount of approved sanitary lubricant
such as Petrol-Gel to the O-ring and the
face of the plastic bushing opposite the
bell portion of the seal. Do not allow any
lubricant to come into contact with the
bell-shaped rubber portion of the seal.
3. See figure 11-2. Install the shaft
seal over the rear of the beater shaft with
the bell-shaped portion facing the rear.
Important:
Shake blades have 3 holes and are
not interchangeable with the 2 hole
soft serve blades. If the incorrect
blades are used the freezer could be
damaged.
4. Place the scraper blades on the
beater shaft, making sure the blades are
installed properly.
— continued
45