H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 25

ELECTRO FREEZE Soft Serve Model GEN-2080
5 Part Names and Functions
The following descriptions apply to figure 5-1. The number preceding the
part name corresponds to the number in the figure.
1.) HEAD - ASSY. W/ACTUATOR:
Encloses the freezing cylinder and
provides an opening for product to
be dispensed.
2.) BUSHING - BEATER BEARING:
Holds the beater in place at the front
of the cylinder. Must be inserted
into the head and lubricated before
assembly.
3.) O-RING - HEAD: Seals the head
to the freezing cylinder. Must be
lubricated.
4.)
and
5.) O-RINGS - PLUNGER: (UPPER &
LOWER): Seals the plunger in the
head. Must be lubricated to seal and
slide properly.
6.) PLUNGER - DISPENSING BLACK:
Seals the product opening in the head
when closed. Allows product to flow
when open.
7.) PUSH ROD - ASSY. PLUNGER
SWITCH: Starts the freezer when
dispensing. Must be in place before
freezer will operate.
8.) FUSE - SLO BLOW 1A: Prevents the
spindle motor from overload.
9.) SPINDLE - ASSY. FRONT MOUNT:
Mixes the shake as it is dispensed.
10.) O-RING - SPINDLE ASSY.: Holds the
spindle in place.
11.) POST - PIVOT (Optional): Holds
the handle in place when the spin-
dle is not used.
185240
— Shake
12.) O-RING - PIVOT POST:
Holds the pivot post in place.
13.) HANDLE - ASSY. SPINDLE HEAD:
Opens and closes the plunger to
start and stop the flow of product
from the freezer.
14.) KEEPER - ASSY. SPINDLE: Se-
cures the handle to the head.
15.) KNOB - HAND: Secures the head
to the freezing cylinder.
16.) O-RING - AIR RELIEF PLUG:
Seals the air relief screw in the
head.
17.) PLUG - AIR RELIEF: Seals the
air relief opening in the head when
closed. Allows excess air to be
removed from the cylinder when
filling.
18.) EXTENSION-SHAKE SPIGOT:
Product flows from the head through
the extension.
19.) O-RING-SPIGOT EXTENSION:
Seals the extension to the head.
15