Table of Contents
Advertisement
ELECTRO FREEZE Model CS600
8 Assembly
DO NOT
LUBRICATE
SHAFT SEAL
Figure 8-1
Figure 8-2
Figure 8-3
184596
SEAL-BEATER SHAFT
DO NOT
LUBRICATE
SHAFT SEAL
LUBRICATE WASHER
WASHER
Lubricate shaft seal
Assemble beater shaft
assembly
Lubricate bearing areas of
breaker bar
Correct assembly of the freezer is essential
to prevent leakage of product and damage to
the freezer. To assemble the freezer you will
need an approved lubricant (such as Lubri-
Film Plus). Make sure all parts of the
assemblies have been washed and sanitized
before assembling. Persons assembling the
freezer must first wash and sanitize their
hands and forearms with an approved
sanitizer.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are in
the "OFF" position and that
the main power supply is
disconnected.
1. To assemble the shaft seal, install
the cup seals on the plastic washer. Apply
a moderate amount of approved sanitary
lubricant (such as Lubri-Film Plus) to the
washer. Do not allow any lubricant to come
in contact with the bell-shaped rubber
portions of the seal (figure 8-2). Wipe any
excess lubricant from the beater shaft.
2. Install the shaft seal over the rear of
the beater shaft
3. Apply lubricant to the bearing areas
of the breaker bar and bushing. (See figure
8-3)
4. Slide the breaker bar into the center
of the beater shaft so the bar fits into the
hole in the rear beater shaft disc. Place the
scraper blades on the beater shaft, as
shown in figure 8-2,
5. Insert the assembled beater into the
cylinder by sliding the rear blade along the
bottom of the cylinder. This will center the
beater shaft and allow alignment with the
drive shaft. Rotate and push the beater
assembly until the shank has engaged the
drive shaft.
–continued
13
Advertisement
Chapters
Table of Contents
