H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 37

ELECTRO FREEZE Soft Serve Model GEN-2080
8.2 Disassembly Instructions
Figure 8-3
185240
CAUTION
Make sure freezer is
depressurized before
proceeding.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are
in the "OFF" position and
that the main power source
is disconnected. Some
freezers have more than one
disconnect switch.
CAUTION
To prevent bacteria
growth, remove
ALL O-rings when
disassembling for
cleaning. Failure to do
so could create a health
hazard.
Disassemble Beater Shaft
— Soft Serve (continued)
1. If there is product in the freezer
refer to Section 14, Closing Procedures,
14.2 Draining Product.
2. Remove the plunger rod (8, figure
8-2) by lifting up and swinging the bottom
out and down. Remove the hand knobs
(3) and pull dispensing head (1) straight
out by gently rocking the head from the
studs.
3. Remove the cylinder bushing and
beater shaft from the cylinder.
4. Remove the scraper blades and
shaft seal (figure 8-4) from the beater
shaft.
5. Remove drip tray and insert from
the front of the freezer. (see Replacement
Parts Manual, Panel Assembly)
6. From the front of the head remove
the air bleed plug (7, figure 8-2) and the
two plug O-rings (6).
7. Remove the handle pin (5),
handle (4), plunger (9) and nozzle (2)
from dispensing head.
8. Remove one O-ring (12) from the
head and two O-rings (10, 11) from the
plunger.
9. Remove the cup seal (figure 8-4)
and O-ring from the bushing on the shaft
seal assembly.
10. Remove mix container, cover and
low mix probe from the cabinet.
O-RING
Figure 8-4 Disassemble Shaft Seal
-continued
CUP SEAL
WASHER
27