H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 79

ELECTRO FREEZE Soft Serve Model GEN-2080
17 Troubleshooting Tables
PROBLEM PROBABLE CAUSE
1.
2.
Poor or slow
product recovery.
3.
4. Component or compressor failure.
1. Trouble in compressor condensing circuit
Compressor
2.
does not operate
or operates
improperly.
3. Faulty contactor
4.
1. Head assembly is not installed.
Beater motor
2. Magnetic head switch defective.
does not operate.
3. Component failure.
Compressor and
beater motor
1.
operates only
when dispensing.
185240
Dirty or blocked condenser, restricted air
flow – high ambient temperature.
Thermostat cut-in point out of adjustment
or malfunctioning.
Defective condenser fan motor (air
cooled)
Faulty start capacitor, run capacitor or
relay. (Single phase only)
Disconnected or broken wire in switch or
capacitor relay box.
Cylinder thermostat setting too warm or
thermostat defective.
(continued)
REMEDY
Have condenser cleaned by your
1. local service company; lower ambient
temperature.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
1. Install head assembly.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
69