H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 80

ELECTRO FREEZE Soft Serve Model GEN-2080
17 Troubleshooting Tables
PROBLEM PROBABLE CAUSE
1.
Compressor and
beater motor do
not operate when
2. Component failure.
dispensing.
1. Cabinet setting too low.
2. Defective thermostat.
Cabinet too
cold. (below
35°F [1.7°C])
3. Cabinet solenoid stuck open
4. Cabinet expansion valve set too low.
1.
2.
3. Cabinet switch defective.
Mix sours in
4. Door switch defective.
cabinet.
5.
6. Faulty time delay.
7. Suction pressure too low.
70
Spigot switch(es) defective or out of
adjustment.
Cabinet thermostat defective, set too
warm or tuned off.
Cabinet solenoid defective (does not
open).
Cabinet compressor contactor coil open
(mix sours in night mode only.
(continued)
REMEDY
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
3.
Distributor for service.
Contact your Electro Freeze
4.
Distributor for service.
Contact your Electro Freeze
5.
Distributor for service.
Contact your Electro Freeze
6.
Distributor for service.
Contact your Electro Freeze
7.
Distributor for service.
185240