Safety Decal Locations - H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List

ELECTRO FREEZE Soft Serve Model GEN-1578

Safety Decal Locations

Do not attempt to operate the freezer
until all safety precautions and operating
instructions in this manual are read and
understood.
Take notice of all warning, caution,
instruction and information decals (or
labels) on the freezer as shown in the
figure to the right. The labels have been
put there to help maintain a safe working
environment.
The labels have been designed to with-
stand washing and cleaning. All labels
must remain legible for the life of the
freezer. Check labels periodically to be
sure they can be recognized as warning
labels.
If it is necessary to replace any label,
please contact your local authorized
Electro Freeze Distributor or H. C. Duke
& Son, LLC. When ready to order, you will
need to determine the (1) part number,
(2) type of label, (3) location of label, and
(4) quantity required, and include a return
shipping address.
No. Part No.
1
HC165025
2
HC165246
3
HC165048
4
HC165126
You may contact your local authorized
Electro Freeze Distributor, as follows:
Name:
Address:
Phone:
or, for factory service assistance, contact
H. C. Duke & Son, Electro Freeze Service
Department by phone, FAX or e-mail:

(The decals on the next page are
numbered 1, 2, 3 and 4. Those numbers
correspond to the numbers in the table
below. The table provides the part
number, description, and quantity for each
decal.)
Description (Qty)
Decal — Beater Warning (1)
Decal — Pressurized System Warning (2)
Decal — Warning Rotating Parts (2)
Decal — Panel Removal Warning (3)
iv
Phone: (309) 755-4553
(800) 755-4545
FAX: (309) 755-9858
E-mail: service@hcduke.com