H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 21

ELECTRO FREEZE Soft Serve Model GEN-2080
4 Part Names and Functions
The following descriptions apply to figure 4-2. The number preceding the
part name corresponds to the number in the figure.
1.) BUSHING - CYLINDER: Holds the
beater in place at the front of the cyl-
inder. Center must be lubricated.
2.) SHAFT - ASSY. BEATER: Rotates
in the freezing cylinder, blending air
and mix as it ejects product.
3.) BLADE - SCRAPER SOFT SERVE:
Scrapes the frozen product from the
freezing cylinder wall.
Soft serve blades only have 2 holes
and are not interchangeable with the
3 hole shake blades. If the incorrect
blades are used the freezer could be
damaged.
4.) O-RING - SHAFT SEAL: Seals the
beater shaft to the shaft seal. Is
inserted into the shaft seal bushing.
Must be lubricated.
5.) WASHER - SHAFT SEAL: Holds
the shaft seal o-ring. Lightly lubri-
cate the side opposite the cup
seal.
6.) SEAL(CUP) - BEATER SHAFT:
Seals the opening between the
freezing cylinder and the beater
shaft. Do not lubricate rubber cup
portion.
185240
Important:
— Soft Serve
11