H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 73

ELECTRO FREEZE Soft Serve Model GEN-2080
16 Routine Maintenance
C. MTS Cover Switch
The MTS cover switch feature is designed
to prevent the MTS gear motor from being
accidentally activated. It is essential that the
proper operation of this switch be verified on a
routine basis. Use the following instructions to
test for proper operation:
NOTE: Freezer should be cleaned and
disassembled for this test.
1. Be sure all switches are in the "OFF"
position.
2. Remove the MTS cover to expose the
roller assembly.
3. Turn MTS switch to "ON".
4. Look at the MTS rollers; they should
NOT be rotating. If they are rotating, turn
A. Air Condenser.
Important:
Never use a screwdriver or sharp
object to clean between fins.
Both air and water cooled freezers have
an air condenser. The condenser fins
need to be cleaned by your Electro
Failure to properly maintain/clean your air condenser can cause
premature compressor failure. Compressor failure due to improper
185240
MONTHLY (
CAUTION
Make sure system is
depressurized before
proceeding.
CAUTION
DO NOT place hands
near the MTS rollers.
Severe personal injury
could result.
QUARTERLY
condenser care will void the compressor warranty.
(continued)
continued)
"OFF" mix switch and discontinue use until
repairs can be made.
5. If there is no movement, slowly
install cover and listen for the gear motor
to turn on. The cover should be almost
completely closed when the gear motor
turns on.
objects into roller cavity during this test. If
the MTS does not operate as described
here, or you are unable to determine if the
MTS is operating properly, turn the switches
to the "OFF" position, disconnect the main
power supply and contact your service
technician or the factory. DO NOT place
the freezer in service until the problem has
been corrected.
D. Replace the Mix Transfer
Hose
Make sure the freezer
is depressurized before
proceeding.
To avoid electrical shock or
contact with moving parts, make
sure all switches are in the
"OFF" position and that the main
power supply is disconnected.
Some freezers have more than
one disconnect switch.
Freeze Distributor to remove dirt, lint and
dust.
B. Refrigeration System
Have your Electro Freeze Distributor check
the refrigeration system and make any
necessary adjustments.
WARNING!
DO NOT insert fingers or
CAUTION
CAUTION
63