H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 53

Combination soft serve and shake freezer
Hide thumbs Also See for Electro-Freeze Genesis Series:
Table of Contents

Advertisement

ELECTRO FREEZE Soft Serve Model GEN-2080
10 Assembly
Figure 10-7 MTS
19. Refer to figure 10-7. Install the
MTS hose assembly by first placing the
clamp next to the braided hose, above
the roller bearing support on the right side
and push hose into slot. Place the transfer
hose under the rollers. While holding the
pickup tube stretch the hose so the left
hand clamp is above the roller bearing
support and push the hose into the slot.
Do not twist the hose assembly while
installing.
20. Check to ensure the transfer
hose is straight and centered on the
roller assembly making sure the locating
line is facing out. The line should be in
the same position at the inlet and outlet
guides of the roller bearing support, as
shown in figure 10-7.
21. Swing the shoe over hose and
185240
— Soft Serve (continued)
Important:
tighten the swing clamp hand knob in
place until it bottoms out and will not turn
any further.
22. Insert the air tube into the
retainer in the back of the cabinet.
23. Insert the MTS cover over stud
see figure 10-8. Hose clamps should
be exposed. Tighten cover knob. Hand
tighten only.
Important:
The MTS will not operate unless the
cover is installed and secured by the
hand knob.
24. Loop the braided hose towards
you and slide the hose over the cylinder
inlet tube. Tighten the clamp. Make sure
the braided hose is not twisting transfer
hose.
— continued
43

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gen-2080

Table of Contents