H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 42

ELECTRO FREEZE Soft Serve Model GEN-2080
9 Disassembly and Cleaning
Safety Information
This freezer uses pressure to assure
consistent product quality. It is important
for your safety that the freezer is
depressurized slowly and completely
whenever the freezer is to be drained,
disassembled, cleaned, or serviced. The
safety instructions in this manual will
remind you when to check to make sure
the freezer is depressurized. When you
see this CAUTION statement
the following steps should be taken:
1. Using the buttons L2 & R2 on the
control panel be sure both MTS pumps
are in the "OFF" position.
2. Turn the control pad "OFF" and then
turn "OFF" the main power switch.
3. Place a clean bucket under the
dispense head.
4. Slowly open the spigots, allowing
any pressurized cleaning solution or
air to escape. If there is product in
the freezer refer to Section 9, Closing
Procedures, 9.1 Draining Product.
5. Remove the spigot switch rods and
open the spigots completely.
6. Inside the refrigerated cabinet,
remove the MTS cover, loosen the shoe
clamp hand knob, swing back the shoe
clamp and swing open the roller shoe on
both mix transfer systems.
Following these steps will assure that the
system is depressurized.
32
CAUTION
Make sure freezer is
depressurized before
proceeding.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad
is "OFF" and that the main
power switch is "OFF".
— Shake
It is important that the freezer
be disassembled, washed,
lubricated and sanitized before
operation.
The cleaning and sanitizing instructions
explained in this manual are required to
maintain a clean, sanitary freezer. The
freezer should be disassembled, cleaned,
reassembled, lubricated and sanitized
daily to ensure the best possible product
quality and freezer operation.
Persons assembling, cleaning or
sanitizing the freezer must first wash
and sanitize hands and forearms with an
approved sanitizer.
185240