Cleaning And Lubricating - Mts Assembly - H.C Duke & Son Electro Freeze GENESIS Series Operator’s Manual With Illustrated Parts List

ELECTRO FREEZE Soft Serve Model GEN-5099

7.3.1 Cleaning and Lubricating - MTS Assembly

NOTE: Clean the shoe weekly or when
necessary. Do not interchange the shoe
with any other MTS shoes.
Follow these directions for each MTS
shoe:
shoe off of the pivot arm and the swing
clamp off of the clamp arm. See figure
6-11.
detergent with the brush provided and dry
thoroughly.
clean with water bottle.
SHOE SWING CLAMP
O-RING
WASHER
KNOB
Figure 7-11
26
1. Remove the O-rings and slide the
2. Carry to the sink, wash in mild
3. Brush in between rollers. Flush
RIGHT SIDE SHOWN
LEFT SIDE THE SAME EXCEPT MIRRORED
LUBRICATE WITH FOOD
GRADE LUBRICANT
SWING CLAMP ARM
O-RING
PRESSURE RELIEF SPRING

Do not let shoe sit in sanitizing
solution or water. Corrosion will occur
in bore.
4. Lubricate the shoe pivot arm and
the swing clamp arm with food grade
lubricant such as Petrol-Gel.
5. Reassemble the shoe and O-ring
on pivot arm.
6. Reassemble the shoe swing
clamp and O-ring on the swing clamp
arm.
BRUSH BETWEEN ROLLERS
LUBRICATE WITH FOOD
GRADE LUBRICANT
SHOE PIVOT ARM
ROLLER SHOE
Important:
M02082
185242