H.C Duke & Son Electro-Freeze Genesis Series Operator’s Manual With Illustrated Parts List page 48

ELECTRO FREEZE Soft Serve Model GEN-2080
8.3 Cleaning Instructions
c. the shaft cup seal, plastic
washer, plunger O-ring grooves, as
shown in figure 9-8.
Figure 9-8
scraper blade pin holes, as shown in
figure 9-9.
Figure 9-9 Scraper Blade Pin Holes
3. After all parts are washed, rinse
and then place in the sanitizing solution.
Brush the inside of all mix transfer hoses
Figure 9-10 Brush inside of cylinder
38
Clean Shaft Seal and
Plunger O-ring Grooves
d. the beater shaft and the
mix feed tubes.
— Shake (continued)
with sanitizer. For proper
sanitizing the parts must remain fully
immersed in the sanitizer for 5 minutes.
Allow parts to air-dry after sanitizing.
4. Using a warm mild dish detergent
solution thoroughly brush:
a. the mix feed tubes from the
cabinet to the cylinders (figure 9-10)
b. the inside of the cylinders
making certain to clean the back walls,
and the inside of the drain tubes, as
shown in figure 9-11. Dip the brush in
the dish washing solution and force into
the drain tube until it stops - repeat until
clean.
5. Wash the drip tray and insert in
the warm dish detergent solution and
rinse with clear water.
6. Wash the outside of the freezer
and the inside of the cabinet with the
dish detergent solution. Rinse with clear
water.
Figure 9-11 Brush the inside of the
Cylinders and Drain Tubes
185240