Standards And Directives Complied With; Cpr Conformity And Firmware Version; Release Notes - Siemens FS20 Commissioning, Maintenance, Troubleshooting

Safety
2

Standards and directives complied with

2.3 Standards and directives complied with

2.3.1 CPR conformity and firmware version

2.4 Release Notes

20 | 188
Building Technologies
Fire Safety
A list of the standards and directives complied with is available from your Siemens
contact.
In order to satisfy Ordinance No. 305/2011 (the Construction Products Regulation –
CPR), the firmware of a newly installed fire detection installation must be current
market package version MP6 or higher.
NOTICE
Firmware version of a newly installed fire detection installation not updated
No CPR conformity
● Compare the firmware version of a newly installed fire detection installation
with the firmware version MP6.
● Update the firmware if necessary.
Limitations to the configuration or use of devices in a fire detection installation with
a particular firmware version are possible.
WARNING
Limited or non-existent fire detection
Personal injury and damage to property in the event of a fire.
● Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
● Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
NOTICE
Incorrect planning and/or configuration
Important standards and specifications are not satisfied.
Fire detection installation is not accepted for commissioning.
Additional expense resulting from necessary new planning and/or configuration.
● Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
● Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
009052_s_en_--
2016-06-02