Siemens FS20 Commissioning, Maintenance, Troubleshooting page 14

About this document
1
Revision history
Version Edition date
o 2013-01
n 06.2012
m 05.2012
l 07.2010
k 05.2010
14 | 188
Building Technologies
Fire Safety
Brief description
Revised:
Firmware update updated
Replacing a device without SintesoWorks
Chapters 'Removing or replacing non-stationary devices' and 'Changing and
expanding the detector line' have been combined into one new chapter called
'Changing and expanding the FDnet/C-NET detector line'
Firmware update FDCW241
CPR replaces CPD: The Construction Products Regulation (CPR 305/2011)
replaces the previous Construction Products Directive (CPD 89/106)
Chapters 'B1 - Commissioning standalone 'Station' with PC, without pre-
configuration' and 'B2 - Commissioning standalone 'Station' with PC, with pre-
configuration': Only applicable to FDnet detector lines
'Definition of terms' chapter revised
Chapter 'Setting Windows firewall' updated for Windows 7
Addition to chapter 'Setting Windows firewall', for Windows 7
Edition for MP-EN 4.0
New:
Updating the firmware of the main
CPU and additional CPUs in a
single step
Updating the firmware of a modular
station with CPU card(s)
Updating several 'Stations'
simultaneously
Update the firmware of the
additional CPUs via GAP
Commissioning FC2080
Commissioning FG2020
Creating a backup of the'Site'
configuration
Replacing FDnet device: 20 s wait
time instead of 40 s
Updating the firmware of the
peripheral devices: Resetting the
line card no longer necessary
Updating the firmware of the radio
gateway FDCW241
Commissioning of I/O card (remote
transmission) FCI2007-A1 and I/O
card (horn/monitored) FCI2009-A1
Revised chapters: "Loading configuration from the PC to the 'Station'", "Updating
the firmware of the 'Station'"
Edition for MP3.0:
Revision history redefined and standardized
Ethernet switch (MM) FN2008-A1 and safety module (firewall) FN2009-A1 added
"Merging two sites" chapter added
Chapter on 'Site' conversion removed. Reference to doc. A6V10244961 'Site
conversion' added.
Revised chapters: "Updating 'Station' firmware", "Restarting 'Station'", "Restoring
'Station' to factory setting"
Revised:
Creating diagnosis report
Restart the station
Commissioning the sounder base FDSB291
Checking 'Site' function
Restoring factory settings
Addition to chapter 'Possible error
messages', for collective detector lines
Checking the detector line
Testing detector with detector exchanger
and tester or intelligent detector tester
Replacing non-stationary devices of
different types
009052_s_en_--
2016-06-02