Fcc Compliance; References - Emerson Daniel 3410 Series Installation Manual

Installation manual
DAN-20057315
—
Approval agencies
• UL
• c-UL
• DEMKO
• INMETRO
• NEPSI
• GOSTR
Important
Please consult Flow Lifecycle Services for Daniel products for the complete metrology
approvals list.
1.11

FCC compliance

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
NOTICE
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
1.12

References

1. Gould Modbus Protocol Reference Guide, Rev. B, PI-MBUS-300
2. Measurement of Fuel Gas By Turbine Meters, American Gas Association,
3. Compressibility Factors of Natural Gas and Other Related Hydrocarbon Gases,
4. Speed of Sound in Natural Gas and Other Related Hydrocarbon Gasses, Report 10,
5. Manual of Petroleum Measurement Standards, Chapter 21 — Flow Measurement
Model 3418 GUSM
International Organization of Legal Metrology (OIML)
Transmission Measurement Committee Report No. 7, Second Revision, April 1996
(also referred to as AGA7)
American Gas Association, Transmission Measurement Committee Report No. 8,
Second Edition, Second Printing, July 1994 (also referred to as AGA8)
First Edition, May 2003 (also referred to as AGA10)
Using Electronic Metering Systems, Section 1 — Electronic Gas Measurement,
American Gas Association and American Petroleum Institute, First Edition,
September 1993
Introduction
June 2019
27