Sealing The Unit - Emerson Daniel 3410 Series Installation Manual

Installation manual
DAN-20057315
6. Check that the seal is properly fitted to prevent the latch from lifting. Verify the
3.7

Sealing the unit

The unit should be properly sealed after electrical connections have been tested according
to the customer's Best Practices schedule. Some areas require a witnessed Acceptance
Test for the installed system and require that the meter run for a predetermined length of
time (approximately one to two weeks) before the unit is sealed. This allows time to verify
all electrical connections are correct, that the meter is accurately measuring flow and that
the meter meets the customer's installation requirements. See
use explosion-proof conduit
Model 3418 GUSM
latch is secure and clip off any extra wire extending from the seal.
and Startup for systems that use flame-proof
Electrical installation
June 2019
Startup for systems that
cable.
81