Emerson Daniel 3410 Series Installation Manual page 50

Electrical installation
June 2019
3. Remove the end cap nearest the conduit entry to gain access to the transmitter
4. Pull the wires into the electronics enclosure. Complete the field connection wiring
5. Complete the field connection wiring and apply electrical power to the system.
50
WARNING
HAZARDOUS VOLTAGE INSIDE
Do not open the Transmitter Electronics Enclosure when an explosive gas
atmosphere is present. Disconnect equipment from supply circuit before opening
the enclosure.
Failure to remove power may result in serious death or injury.
electronics.
as shown in see Figure 3-3 and Wiring and inputs/outputs.
Installation manual
DAN-20057315
Installation manual