Introduction
June 2019
CONTENTS MAY BE HAZARDOUS
The meter must be fully depressurized and drained before attempting to remove the
transducer holder of T-Slot transducer assembly, or the T-200 transducer assembly. If
gas or fluid begins to leak from the transducer holder of T-Slot transducer assembly, or
T-200 transducer stalk assembly, stop immediately and reinstall the transducer holder
or T-200 stalk assembly.
Failure to comply may cause serious injury or equipment damage.
A. Transducer holder
ESCAPING GASES OR FLUIDS HAZARD
The purchaser of the meter is responsible for the selection of Daniel components/seals
and materials compatible with the chemical properties of gas flow measurement.
Failure to select the suitable meter component/seals may cause escaping gases or
liquids, resulting in injury or equipment damage.
Consult your Daniel Sales and Service representative to ensure you purchase the correct
components and seals for your application. Specifications for Daniel Gas Ultrasonic Flow
Meter model 3418 are below:
Table 1-1: Daniel model 3418 meter specifications (part 1)
Daniel 3418 meter specifications
Meter type
18
WARNING
CAUTION
Number of paths
•
3418: 8-path chordal design
Ultrasonic type
•
Transit-time based measurement
•
Spool piece with integral mount transducers
Installation manual
DAN-20057315
Installation manual