Meter Specifications For 3418 Model - Emerson Daniel 3410 Series Installation Manual

Installation manual
DAN-20057315
Figure 1-3: Transmitter electronics enclosure with local display and glass endcap
All Daniel ultrasonic flow meter's U.L. safety listing is accomplished through the
combination of an explosion-proof transmitter electronics enclosure that houses the CPU
module, Power Supply board, I.S. Barrier board, Backplane board and optional LCD Display
board.
Note
The optional LCD Display requires firmware v1.04 or later and Uboot version, January 31,
2013.
The Base Electronics Enclosure that houses the Acquisition Module. Intrinsically safe
transducers and cable assemblies are designed for Class 1, Division1, Groups C and D areas
without need of further protection when installed in accordance with the field wiring
diagram (refer to Daniel drawing DMC-005324 see
1.7

Meter specifications for 3418 model

CONTENTS MAY BE UNDER PRESSURE
When the meter is under pressure, DO NOT attempt to remove or adjust the transducer
holder of the T-Slot transducer assembly, or loosen the screws holding the T-200
transducer assembly.
Attempting to do so may release pressurized gases, resulting in serious injury or
equipment damage.
Model 3418 GUSM
WARNING
Engineering drawings).
Introduction
June 2019
17