Table of Contents
Advertisement
®
R&S
NGE100B
Parameters:
<Time>
[SOURce:]VOLTage:RAMP[:STATe] <arg0>
This command defines/queries the EasyRamp state for the previous selected channel.
Parameters:
<arg0>
6.5.13 Arbitrary Commands
ARBitrary:CLEar
This command clears the previous defined arbitrary waveform data for channel 1.
Usage:
ARBitrary:DATA <arg0>
Defines or queries the arbitrary points for channel 1. The dwell time between two
points is from 10ms to 600s.
Parameters:
<arg0>
Example:
ARBitrary:RCL <arg0>
This command recalls EasyArb settings and previous defined arbitrary points from the
respective memory locations M1-M5.
Parameters:
<arg0>
User Manual 5601.1343.02 ─ 04
Range:
0.010 to 10
*RST:
0.010
Default unit: ms
{OFF | ON}
ON
EasyRamp function is activated.
OFF
EasyRamp function is disabled.
Event
<Voltage1, Current1, Time1, Voltage2, Current2, Time2,..., Volt-
age128, Current128, Time128>
Voltage1 ... Voltage128
Defines the arbitrary points of the voltage.
Current1 ... Current128
Defines the arbitrary points of the current.
Time1 ... Time128
Defines the arbitrary points of the time (The unit for time is ms).
ARB:DATA "10.5,3,10,20,2,1000,15,2.1,10000"
Range:
0..4
Remote Control
Remote Control - Commands
91
Advertisement
Table of Contents
