Table of Contents
Advertisement
®
R&S
NGE100B
Figure 4-4: Rear panel of R&S NGE100B
7 = AC inlet with fuse holder
8 = Voltage selector
9 = Ethernet (LAN) connector
10 = USB connector
11 = Digital I/O connector
AC inlet with fuse holder
Main supply cord
Do not use detachable mains supply cord with inadequate rating.
For safety reasons, the instrument can only be operated with authorized safety sock-
ets.
The power cable must be plugged in before signal circuits can be connected. Never
use the product if the power cable is damaged. See
Instrument",
Voltage selector
The voltage selector selects the mains voltage between 115 V and 230 V.
Ethernet connector
This connector is used for establishing remote control via SCPI or LXI. See section
"Ethernet Setup" in the user manual for more information on the connection setup.
The Ethernet option NGE-K101 must be installed for this function to be available in the
instrument.
USB connector
The USB connector is a Type-B connector for remote control operation via USB TMC
or USB VCP.
User Manual 5601.1343.02 ─ 04
on page 23 for more information.
Quick Start
Instrument Tour
Chapter 4.2.2, "Switching On the
22
Advertisement
Table of Contents
