Table of Contents
Advertisement
®
R&S
NGE100B
Example:
OUTPut:MODE?
Queries the output operating mode of the previous selected channel
Return values:
<arg0>
Example:
Usage:
OUTPut:SELect <arg0>
This command activates or queries the instrument channel state of the previous
selected channedl.
If the selected channel is activated, the respective channel key (i.e. Ch 1, Ch 2, Ch 3)
on the front panel will be illuminated.
Parameters:
<arg0>
User Manual 5601.1343.02 ─ 04
INST OUT1
OUTP:SEL ON
Volt 12
Curr 0.1
Ch 1 is activated.
INST OUT2
OUTP:SEL ON
Volt 12
Curr 0.2
Ch 2 is activated.
OUTP:GEN ON
Ch 1 and Ch 2 and Output state are activated.
OUTP:GEN? -> 1
Return output state of the channel.
{OFF | CV | CC}
OFF
Output is turned off.
CV
Output mode changed to constant voltage mode.
CC
Output mode changed to constant current mode.
*RST:
OFF
OUTP:MODE? -> CV
Output mode has changed to constant voltage mdoe.
Query only
{OFF | ON | 0 | 1}
ON | 1
Selected channel will be activated.
OFF | 0
Selected channel will be deactivated.
*RST:
OFF | 0
Remote Control
Remote Control - Commands
82
Advertisement
Table of Contents
