Dio Commands - R&S NGE100B Series User Manual

®
R&S NGE100B
ARBitrary:STARt
This command starts the previous transferred EasyArb waveform in channel 1 if Easy-
Arb is enabled.
Usage:
ARBitrary:STOP
This command stops the EasyArb waveform in channel 1 if EasyArb is running.
Usage:

6.5.14 DIO Commands

TRIGger:DIRection:DIO<IO> <arg0>
This command sets or queries the specified Digital I/O line to function as Trigger Input
or Trigger Output.
Suffix:
<IO>
Parameters:
<arg0>
Example:
TRIGger[:ENABle]:DIO<IO> <arg0>
This command sets or queries the state of the specified Digital I/O line.
The state is disabled when any setting has been changed
Suffix:
<IO>
Parameters:
<arg0>
TRIGger:IN:ARBitrary:DIO<IO> <arg0>
This command sets or queries the operation mode when starting EasyArb by Trig IN.
User Manual 5601.1343.02 ─ 04
Event
Event
.
1..4
OUTPut | INPut
TRIG:DIR:DIO2 OUT
.
1..4
{OFF | ON}
ON
Enable the state for Digital I/O line.
OFF
Disable the state for Digital I/O line.
Remote Control
Remote Control - Commands
93