R&S NGE100B Series User Manual page 95

®
R&S NGE100B
Usage:
ARBitrary:REPetitions <Repetitions>
This command defines or queries the repetition of the defined arbitrary waveform for
channel 1.
Note: If the repetition is set to "0", the arbitrary waveform repeats continuously.
Parameters:
<Repetitions>
Example:
ARBitrary:POINts?
This command returns the number of arbitrary points of EasyArb waveform.
Return values:
<arg0>
Usage:
ARBitrary[:STATe] <arg0>
This command activates/deactivates or queries the EasyArb state. ON: Ch 1 is ready
to run arb waveform.
Parameters:
<arg0>
ARBitrary:SAV <arg0>
This command saves EasyArb settings and previous defined arbitrary points into the
respective memory locations M1-M5.
Parameters:
<arg0>
Example:
Usage:
User Manual 5601.1343.02 ─ 04
Setting only
0..255
ARB:REP 10
Set the repetition rate of the defined arbitrary waveform as 10.
ARB:REP? -> 10
Return the defined repetition rate of the selected channel.
Query only
Range: 0..4
INST 1
ARB:DATA 10,1,0,5,0
ARB:REP 10
ARB:SAV 1
Setting only
Remote Control
Remote Control - Commands
92