Turn-On Self-Test - Chroma 63800 Series Operation & Programming Manual

Programmable AC/DC Electronic Load 63800 Series Operation & Programming Manual

2.3.3 Turn-On Self-Test

Check the following before turning on the Load.
1. The unit has been set to the correct line voltage by factory. Refer to the line voltage
indicated on the left hand side of the panel.
2. The power cord is connected to the AC input socket.
WARNING
The power supplies a chassis ground through a third connector. Be sure
that your outlet is of three-conductor type with the correct pin connected
to ground.
Turn on the Load by the power switch on the front panel and observe the display. Immediately
after turning on, the Electronic Load executes a self-test and checks the GPIB interface board
and identify the information of the system.
The LCD displays
A U T O
and then it goes to the output mode setting display.
2-2
Figure 2-1 Line Voltage Switch
S E L F
O K ! !
T E S T I N G . . .