Table of Contents
Advertisement
Multi-Channel Sync Hipot Tester 19020/19020-4/19021/19021-4/19022/19022-4
User's Manual
FAIL State:
Test Result Display
FAIL
To stop the test output in any condition, press STOP.
1.
2.
3.
4.8.5 Test Procedure for PA Test
1.
Connect the UUT following the connection method described above.
2.
In the power on screen shown below:
Position 1
TEST – 1/2
MODE CH
01
02
03
04
05
PA
06
07
08
09
10
STANDBY
Illustration:
"PA" means it is in pause mode. "SOURCE" is the message string to be displayed during
the pause mode and "RES." is the test result.
3.
Press
to prepare for the test. The status line shows "STANDBY".
STOP
4. Press
to activate the test.
START
When this key is pressed it starts PA MODE. If the test time is set for PA MODE, the
status line will show a countdown timer. If the test time is set to CONTINUE, the status
line will show PAUSE and wait for the input of a START signal to end the PA MODE.
4-28
Meaning
The Open/Short Capacitance reading exceeds the OPEN/
SHORT setting.
Every time a cable or fixture is changed for an OSC test, be sure to
run OFFFSET in advance to ensure the test accuracy.
Run GET Cs when testing a new UUT or replacing a UUT for the
OSC tests. Read the standard capacitance from the test sample as
the standard value.
To use OSC GET CS, see section 4.7.3 for detailed information.
SOURCE
LIMIT
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
REMOTE LOCK
Position 2
RES.
RECALL
OFFSET
GET Cs
CLEAR
SLAVE
1 2 3 4 5 6 7 8 9
CORR
ERROR
Advertisement
Table of Contents
