Cf Only - Chroma 63800 Series Operation & Programming Manual

6. Press 0 , . , 7 , 8 then press ENTER to change the value to "0.780".
P s e t = 2 2 0 0 . 0
I p ( m a x ) = 3 0 . 0
7. Move the cursor by pressing ( ◄, ► ) to the command line of "I
P s e t = 2 2 0 0 . 0
I p ( m a x ) = 3 0 . 0
8. Press 2 , 5 then press ENTER to change the value to "25.0".
P s e t = 2 2 0 0 . 0
I p ( m a x ) = 2 5 . 0
9. After setting the parameter of the load, the LOAD ON/OFF key should be pressed to turn
on the load, so that the load can sink the current. (For the detailed information please refer
section 3.4.5.)
If there is error during the procedure of inputting value, press CLEAR to clear
the value at any time and then input again.

3.8.2 CF Only

For switching to CF only mode, the procedures are as below:
1. Press CONF./LOCAL key.
2. Press 1 , then press ENTER to enter SETUP. (The display please refer 3.8.1 BOTH
mode.)
3. Move the direction key ( ▲, ▼ ) to "1-5. CF/PF SETTING".
4. Press the direction key ( ◄, ► ) or rotate the rotary knob to choose "CF", then press
ENTER. (The display please refer 3.8.1 BOTH mode)
5. Then press CP to back to main page.
Users can press the arrow key to select the setting parameters on the LCD display, including
power value, CF, and I
C F = 2 . 0 0 0
C F = 2 . 0 0 0
C F = 2 . 0 0 0
(max).
p
Local Operation
P F = 0 . 7 8 0
U N I T : W , A
(max)=".
p
P F = 0 . 7 8 0
U N I T : W , A
P F = 0 . 7 8 0
U N I T : W , A
3-27