Test Procedure For Pa Test - Chroma 19020 User Manual

Multi-Channel Sync Hipot Tester 19020/19020-4/19021/19021-4/19022/19022-4
User's Manual
FAIL State:
Test Result Display
FAIL
To stop test output in any condition, just press STOP.
1.
2.
3.

4.8.5 Test Procedure for PA Test

1. Connect the UUT properly following the connection method.
2. In the power on screen shown below:
Position 1
TEST – 1/2
MODE CH
01
02
03
04
05
PA
06
07
08
09
10
STANDBY
Illustration:
PA means it is in pause mode. "Position 1" is the message set to display and "Position 2"
is the test result.
3. Press to prepare for test. The status line shows "STANDBY".
STOP
4. Press to activate the test
START
When this key is pressed it starts PA MODE. If action time is set for PA MODE, the
status line will show a counter to count down. If the test time is set to CONTINUE, the
status line will show PAUSE and wait for the input of START signal to end PA MODE.
4-28
Meaning
The Open/Short Capacitance reading exceeds the OPEN/
SHORT setting.
Every time the cable or fixture is changed for OSC, be sure to run
OFFFSET in advance to ensure the test accuracy.
It is necessary to run GET Cs when testing a new UUT or replacing a
UUT for OSC tests. Read the standard capacitance from the test
sample as the standard value.
For using OSC GET CS, see section 4.7.3 for detail information.
SOURCE LIMIT
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
PAUSE-MODE
REMOTE LOCK
Position 2
RES. RECALL
OFFSET
GET Cs
CLEAR
SLAVE
1 2 3 4 5 6 7 8 9
CORR ERROR